Your router was not successfully setup

Your router was not successfully setup
If you are getting this type of error messages. You can Try the following Steps. 1. Check you Connection Between the modem and router to Computer. They are connected with Ethernet Cable in the right way. Modem is connected to router and then router is connected through computer. and Power light of the router is on.
2. On the router there is Reset Button on the back of the router Press and hold the Reset button with a paperclip or pin until the light starts blinking (about 10 seconds). Install the router again.
3. Temporarily disable your computer's firewall.
4. Open the web browser and type myrouter.local or 192.168.1.1 or Linksyssmartwifi.com To Setup Linksys Router.
5. Follow the Steps.
6. If you have another computer, use that computer to install the router again.
IF you still facing issue with Linksys Router then call us or chat with our experts he will help you.

Comments

Post a Comment

Popular posts from this blog

Your Internet cable is not plugged in Message

Image
If you getting an error Message "Your Internet cable is not plugged in" when trying to set up your router, Follow these steps to troubleshooting. 1. Make Sure that Ethernet cable is securely connected with internet port on the router back on the yellow port. it may be named as internet or wan. 2. Make Sure your modem is connected to power and turned on. Make sure modem is switch On. 3. If your internet service is cable, verify that the cable modem's CABLE port is connected to the coaxial cable provided by your ISP. 4. If your internet service is DSL, make sure that the DSL phone line is connected to the modem's DSL port. myrouter.local
Read more